Memphis SE210 Dual 10" Ported Subwoofer Enclosure With Amplifier

The Memphis SE210 is an all-in-one bass package built around a dual 10-inch loaded enclosure and a matched SE2000.1DF mono amplifier. It provides a straightforward way to add dedicated low-frequency output to a vehicle audio system without selecting each major bass component separately. The package is designed for shoppers who want a compact, pre-matched starting point for a trunk or cargo-area bass upgrade.

Its ported enclosure design is intended to emphasize bass output, while the two Street Edge woofers use polypropylene cones and rubber surrounds. Each woofer incorporates a 1.5-inch copper voice coil and Direct Vent Voice Coil Cooling. Together, these features support a focused low-end addition for music that benefits from more impact and depth.

The enclosure is internally wired to a 1-ohm total load at its spring-post terminals. Memphis lists the package at 500 watts RMS and 1,000 watts peak at 1 ohm, with alternate published RMS/peak ratings at 2 and 4 ohms. The included mono amplifier is matched to the enclosure package and includes adjustable bass-management controls.

The SE210 is suited to drivers upgrading a factory or aftermarket audio system that can provide an RCA-level signal to the amplifier. Its included remote level control gives the driver a convenient way to adjust bass level from the listening position. A separate amplifier wiring kit, fuse, and speaker wire are needed to complete installation.

For a practical system build, the SE210 combines the loaded enclosure, amplifier, and remote control in one package while leaving source-unit integration and vehicle-specific installation parts flexible. The enclosure can be used in a trunk, hatch, or cargo area where its dimensions allow adequate clearance and amplifier ventilation. It is a focused bass solution for systems where a separate full-range speaker upgrade may be added later.

Key Features

• Dual 10-Inch Woofers: Two loaded Street Edge subwoofers provide dedicated bass reinforcement.
• Ported Enclosure: Vented cabinet design supports strong bass output.
• Included Mono Amplifier: SE2000.1DF amplifier is supplied as part of the package.
• 1-Ohm Internal Wiring: Enclosure terminals present a 1-ohm total load.
• Copper Voice Coils: 1.5-inch copper coils support the woofer motor design.
• Wired Level Control: Included remote allows convenient bass-level adjustment.

Design & Installation

The SE210 enclosure is constructed from MDF and finished in gray carpet with Custom Street Edge embroidery. Its woofers use polypropylene cones, rubber surrounds, 27-ounce magnets, and Direct Vent Voice Coil Cooling. A single set of spring-post terminals provides the enclosure connection point.

Mount the enclosure securely in a suitable cargo area, leaving room around the amplifier for ventilation and access to controls. Installation requires power, ground, turn-on, signal, and speaker connections; a 4-gauge amplifier wiring kit and a 60-amp fuse are recommended, while wiring, fuse, and installation hardware are not included. Use the amplifier's gain, low-pass, subsonic, bass-boost, and phase controls during setup to integrate the bass package with the rest of the system.